How To Overcome Gas Doesn't Go Up To The Stove: Make Sure The Tubes Are Still Full Until They Change The Auction

Gas stove (unsplash)

YOGYAKARTA The current gas cylinder stove is one of the popular kitchen utensils used. Although quite practical and cheap, problems with stoves can occur. One of the problems that are often experienced is that the gas that is the source of the burning failed to rise to the stove so that the fire does not turn on. There is no need to panic when it happened because the way to deal with gas not going up to the stove is actually very easy.

The LPG tube containing gas and stove is connected to a rubber hose. High pressure gas will come out through the regulator, then enter the hose and appear on the stove stove.

When the gas cannot go up to the stove, there are several things that can be done. Just provide the necessary equipment such as a screwdriver and a tang. Here are the procedures.

When you find that the gas has not managed to get up to the stove, immediately check whether the tube is still gaseous or not. You can confirm the gas pressure through the indicator needle in the regulator. If the indicator needle moves when the regulator is installed, it means that there is still gas in the tube. On the other hand, if there is no movement in the needle then you can replace the new gas cylinder.

Regulators help connect LPG gas cylinders and stoves. The regulator consists of several components, one of which is the rubber hose. If the regulator is not installed perfectly, the gas will not be able to go up to the stove stove.

Gas cylinders can fail to come out due to crustal cloggedness from dry oil mixed with dust or spilled food residue. Usually the crust is in the furnace area. So that the gas can come out, make sure the stove is clean. How to clean it is easy, take off the stove and brush with water and soap. After feeling clean, dry properly until the water is dry and then put it on again.

The potential for blockages in regulators can also prevent gas from getting on the stove. Positions in regulators can occur because of various things, one of which is dirt. Check the regulatory hole that is usually connected to the gas pipe. If there is dirt you can clean it with a brush.

Damage to regulators is very likely. One of the reasons is carat. Karauting regulators not only make gas fail to rise but have the potential to explode, thereby endangering lives.

Leaks in the tube can also make the gas fail to rise. This condition can occur because the rubber hose is Aus and must be replaced immediately. This condition is quite dangerous, it is recommended to replace the gas hose with a new one.

It is also recommended to find out how to store safe LPG gas so that unwanted things do not happen.

Those are some ways to deal with gas not going up to the stove. To get other interesting information, visit VOI.id.