5 Reasons Red Bata Must Be Soaked Before Installing

YOGYAKARTA The red coal is the most widely used construction material for building walls or walls of houses.

Before being used, usually the contrunting workers will first soak the red brick in the water. Why is this procedure carried out?

Soaking red bricks before it is installed is not an arbitrary step, but has a number of technical reasons that are important to pay attention to.

This article will discuss the reason why the red brick must be soaked first before being installed into a building wall. Compiled from various sources, here is the full information!

The procedure for soaking red bricks before installation aims to clean it from dirt.

In addition, the immersion of red bricks is carried out so that the construction material is saturated with water so that it does not absorb cement water.

Dry red coal tends to have very open pores, so they can absorb water quickly from cement complaints. This can cause several problems in the installation process, one of which is the decrease in the mechanical force between bricks and cement complaints.

Bata that has been soaked will have sufficient water levels so that it does not absorb too much water from complaints.

That way, cement mixtures will be stronger and able to better tie bricks, which in turn strengthens the structure of the building.

Soaking bricks will make the brick surface wetter. This condition will help increase the adhesion power between bricks and mortar.

Mortar will be easier to stick and tie with wet bricks, resulting in stronger and longer-lasting connections.

If this building material is not soaked, cement water will be absorbed in red bricks. As a result, the reaction of binding with cement cannot run perfectly and makes the mortar force drop.

Mortar requires enough moisture to harden well. By soaking the bricks first, the humidity in the mortar will be more maintained so that the mortar hardening process can take place optimally.

In addition to increasing adhesion with mortar, the reason for the red brick to be soaked before it is installed is to reduce the risk of cracks on the wall.

The red too dry coal will absorb moisture from the surroundings, including from the cement layer used to unify the bricks.

If the brick keeps pulling the moisture from the cement, the cement will dry up too quickly and can't tie the bricks well.

This causes gaps or cracks between the brick junctions which, if left unchecked, can cause cracks in the walls of the building.

The immersion helps maintain the humidity of the bricks, so that cement complaints do not lose water excessively and the bond between the bricks and cement remains strong.

The red bata that has been soaked is easier to install because the brick does not absorb much water from a mixture of cement. This makes the work of the handyman more efficient, because the cement complaint remains humid and easy to flatten on the surface of the brick. Thus, the installation process can take place faster and the results are neater.

That's information about the reason the brick must be soaked first before it is installed. Get other selected news updates only on VOI.ID.