Understanding And How To Install A Motherboard Front Independently At Home

YOGYAKARTA Cable front panel motherboard on a computer cannot be underestimated. Sometimes it is considered complicated by some people, even though the way it is installed is simple and can be done alone at home. On the other hand, the components of the motherboard component are also very important.

It should be noted that the front panel is a collection of cables that connect reset and power buttons with LED lights in the motherboard casing in the CPU. These cables are built on PC or computer casings.

When the PC owner presses the power button, the engine will start working and the LED lights will start running. The system is running because of the motherboard front panel.

Some of the features on PC panel fronts also vary from PC system power buttons, reset buttons to restart PC systems, power lights as PC indicators, hard drives, USB ports, and audio Jack plugs.

When the cable is not installed properly, the above facility does not work properly so you must make sure everything is installed properly.

How to install a simple motherboard front panel cable is actually simple. It must be noted first that the Header of the Front Panel or Front Panel Connector (Front Panel) is the connector on the motherboard associated with several buttons, namely power on/off, power reset, bi-code speaker, and LED lights in the PC chassis.

Then how to connect and install front panel cables with a motherboard? The following is the procedure reported by Motherboard Scan.

1) Get the power button and control of the panel up front to the existing port. On the lower edge of the motherboard, under the pin in the lower right corner there will be a small letter that reads + LED POWER and + LED HDD, the system panel.

You also have to find and match the corresponding header on the right side of the PC casing. The characteristic is a small cable with a thin plastic tube at the ends. Usually it can be seen hanging on the space part of the drive.

The plastic pieces are written such as HDD LED+, HDD LED-, PLED+, PLED-, RST SW, and POWER SW, including connections to power buttons, reset keys, and HDD lights.

2) It should be noted that most PC casings are now equipped with multiple USB ports, both in front of which are connected to ports and connectors used for the system.

In front of the casing there are two USB headers, masung-each for USB2 port and the rest USB3. Pay attention to the installation of the correct USB header on the motherboard to get the right USB speed. This also applies to USB type-C. Also pay attention to the header on the motherboard because there are still motherboards that do not support USB Type-C connectors.

3) The installation of headphones and microphone jacks can be done last. This cable label is usually labeled HD AUDIO, or accompanied by an AC '97 cable.

HD Audio cable is connected to a header commonly called AAFP or can also be called JAUD1. You can find it under the motherboard, next to the USB2 header.

That's information regarding how to install a motherboard front panel. To get other interesting information, visit VOI.ID.